0 Comment

The Atmel AT89C52 is an based Fullly Static 24MHz CMOS controller Allen Systems; AT89C52 Controller Board Data Sheet for the Atmel AT89C AT89C52 8-bit Microcontroller With 8k Bytes Flash Features. Compatible with MCSTM Products 8K Bytes of In-System Reprogrammable Flash Memory. AT89CPC Microchip Technology / Atmel 8-bit Microcontrollers – MCU 8K Flash 24M datasheet, inventory, & pricing.

Author: Kelabar Vumi
Country: Belize
Language: English (Spanish)
Genre: Career
Published (Last): 17 April 2015
Pages: 27
PDF File Size: 19.5 Mb
ePub File Size: 13.82 Mb
ISBN: 467-7-68610-647-8
Downloads: 22938
Price: Free* [*Free Regsitration Required]
Uploader: Darg

Port 0 also receives the code bytes during Flash program.

AT89C52-24PC – AT89C52 40-Pin 24MHz 8kb 8-bit Microcontroller Technical Data

Read accesses to these addresses will in general return. With the bit set, ALE is active only dur. The EXF2 bit, like.

Each of these interrupt sources can be individually enabled.

Flash array or the lock bits. Timer 2 when it is used as a baud rate generator. EXF2 must be cleared by software.

Atmel AT89C52

The new count value appears in the. In the capture mode, two options are selected by bit. The AT89C52 is normally shipped with the on-chip Flash. The baud rate generator mode is similar to the auto-reload.


Table 4 for Timer 2. To program the AT89C52, take the. A logic 0 at T2EX makes Timer fatasheet count down. The AT89C52 has three lock bits that can be left unpro. Timer 2 external flag set when either a capture or reload is caused by a negative transition on T2EX and. Setting the ALE-disable bit has no. Timer in Capture Mode.

AT89CPC – AT89C52 Pin 24MHz 8kb 8-bit Microcontroller Technical Data

Interrupt Registers The individual interrupt enable bits are. In this mode, P0 has internal. When lock bit 1 is programmed, the logic level at the EA pin. If desired, ALE operation can be disabled by setting bit 0 of.

In fact, the service routine may have to determine. External interrupt 1 enable datasheft. To ensure that a given level is sampled at least.

The AT89C52 has a total of six interrupt vectors: Modes 1 and 3. Voltage on Any Pin. Repeat steps 1 through 5, changing the address.

Same as mode 3, but external. Port 3 pins that dztasheet externally being pulled low will source. Timer 2 interrupt is generated by the logical OR of bits TF2. In addition, the AT89C52 is designed with static logic.


In this mode, the T2EX pin controls. TF2 and EXF2 bits vatasheet generate an interrupt if enabled. It is possible to use Timer 2. Timer 2 Registers Control and status bits are contained in. Port 2 emits the high-order address byte during fetches. Input the desired memory location on the address.

AT89C52 Datasheet(PDF) – ATMEL Corporation

Programming Algorithm Before programming the. AT89C52, the address, data and control signals should be. By combining a versatile 8-bit CPU. In the power-down mode, the oscillator is stopped, and the. Timers 0, 1, and 2and the serial port interrupt.